The Ultrasplice® 2032 is a full-range ergonomic wire splicing system to produce high-quality splices at the lowest cost operation.
AmTech offers this Ultrasplice® system to cover the full range of splices. The Model 2032 is capable of splicing from 0.7 to 32mm2;it utilizes a retractable anvil and will automatically sequence to produce the full range of splices required. All critical splice parameters are monitored to ensure the highest quality splice.
The ultrasonic horn and actuator housing design provides the operator with optimum ergonomic conditions allowing for ease of use.
The Ultrasplice 2032 unit are is easy to maintain and access:
Special ‘keyed connector’ (single point) air and electrical disconnect permit instant replacement of a production actuator at the workstation in under two minutes for off-line maintenance and maximum production.
Critical tooling clearances and alignment do not change with use.
Production of a wide ranges of splices as found on a harness board or in today’s ‘just-in-time’ manufacturing require equipment to automatically adjust. The 2032 automatically and instantly adjusts splice parameters, including splice width, pressure, amplitude, and energy.
Precise, programmable adjustment of splice width
Electronic pressure regulator to accurately control splice force
Electronic amplitude control for precise one-micron adjustment
Quality limits stored in system memory for instant recall and automatic setup
Programmable sequencing of splices for automatic switching after a preset number for optimum production efficiency
Ease of operation -- easy loading and unloading of splices via a fully-retractable anvil providing maximum wire load area and a retractable gather tool for easy splice removal
Patented Anti-Side Splice feature enables the operator to vertically stack the cables to prevents side splicing, thus providing the highest quality splice possible.
